• Suitable for indoor and outdoor use, for horizontal and vertical repairs including counter-gravity.
• Reconstruction of iron cover layer on reinforced or prestressed concrete structures; balconies, cornices, lintels,
• pillars and beams.
• Reconstruction of concrete steps, ornamental pieces, stone walls, etc.
• Repair of surface defects such as cracks or gravel nests.
• Repair of window frames, door frames, bolt anchors, etc.
• Repair of pavements, ramps, canals and bridges due to its high wear resistance.

• Preparation of the substrate: It is necessary to remove any remains of deteriorated, disjointed, unsound or disintegrable concrete, as well as any traces of dust, paint or release waxes. If it is necessary to protect the iron reinforcement, it is essential to remove the thickest traces of rust, brush them and apply a uniform layer of ADIREPAR ANTI-OXID, this product protects the iron from possible future oxidation by means of a method known as anodic passivation. The substrate must be wetted 24 hours before application and this wetting must be repeated just before application.

• Mixing preparation: Add 4.75-5l of water per 25 kg bag of product and knead for approximately 3 min with a low rpm electric mixer to avoid lumps.

• Application of the sample: Apply the mortar with the help of a trowel or by spraying with a thickness between 10 mm and 40 mm. Then compact and trowel the product with a fine trowel. For greater thicknesses, the first layer of mortar should be left to harden for about 30 minutes before applying another layer.

• El espesor mínimo de aplicación debe ser de 5 mm.
• Amasar pequeñas cantidades para asegurar las propiedades del producto en todo momento durante la aplicación.
• No aplicar sobre soportes congelados, en proceso de descongelación o si se prevén heladas.
• En caso de sobreaplicación, se deben rascar las diferentes capas para asegurar la adherencia entre ellas.
• La temperatura de aplicación debe estar comprendida entre 5°C y 35°C sobre el soporte.
• No añadir cemento, arena u otras sustancias que puedan afectar a las propiedades del mortero.
• En aplicaciones donde haya una fuerte insolación después de la reparación, es necesario crear una sombra artificial y humedecer periódicamente la superficie para evitar la formación de microfisuras debido a la excesiva velocidad de fraguado.
• Sobre soportes disgregados, polvorientos, muy absorbentes o expuestos al sol es necesario realizar una imprimación previa con FIXMAR LATEX con un tiempo máximo de curado de dos horas.

PRODUCT

• Appearance Grey colour
• Class R4
• Type PCC
• Grain size 0-2 mm
• Density in powder 1,74 g/cm3

APPLICATION

• Mixing water 18,5%.
• Water ratio 4,75-5l per 25 kg bag
• Setting time 3,5h
• Pot life 1h
• Mixing density 2,09 Kg/cm3
• Average yield 2,09 kg/m2*mm