The mortar REVOCO FINE LAYER has been designed for plastering and finishing plaster in interiors and exteriors. Ideal on concrete blocks and plaster. Especially indicated to obtain a smooth finish, trowelled.

• Preparation of the substrate: clean and dampen the substrates before application. The substrate must be completely hardened, resistant, consistent, clean of dust, paint, oil, etc.
• Preparation of the mixture: add clean running water, knead for 2 minutes, let stand for about 3 minutes and knead again until a homogeneous paste free of lumps is obtained.
• Application of the sample: spread the product with a trowel or by machine on the substrate and smooth it. Wait from 1 to 3 hours before troweling the material.

• Do not apply at low temperatures and high humidity, with rain or with risk of frost.
• The application temperature should be between 5ºC and 30ºC.
• In the joints between supports of different natures and singular points, reinforce the mortar with fiberglass mesh, treated against alkalis.
• To delimit the work zone by means of beads.
• The addition of other material (additives, cement, etc.) can change the behavior and characteristics of the product.
• In case of application on concrete or non-absorbent substrates, a previous application of an adhesion bridge is recommended.
• In case of applying on a surface that is not well regularized and that there may be areas where the maximum thickness of application for this mortar is exceeded, regularize it with REVOCO mortar THICK LAYER.